Справочник Пользователя для Smithco Automobile 78-200-A
5
Service
MAINTENANCE
(CONTINUED)
TIRE PRESSURE
Caution must be used when inflating a low tire to recommended pressure. Over inflating can cause tires to
explode. Tires on the machine should be 18 psi (1.3 bar), castor wheels should be 20 psi (1.4 bar). Improper
inflation will reduce tire life considerably.
explode. Tires on the machine should be 18 psi (1.3 bar), castor wheels should be 20 psi (1.4 bar). Improper
inflation will reduce tire life considerably.
ENGINE OIL KAWASAKI
Change and add oil according to chart below. Do not overfill. Use a high quality detergent oil. For Kawasaki en-
gine API Service Classification: SJ or higher. Use no special additives with recommended oils. Do not mix oil
with gasoline.
gine API Service Classification: SJ or higher. Use no special additives with recommended oils. Do not mix oil
with gasoline.
SAE VISCOSITY GRADES
Starting Temperature Range Anticipated Before Next Oil Change
Use of multi-viscosity oils (10W-30, etc) will result in increased oil consumption. Check oil level more frequently
if using these types of oils.
if using these types of oils.
WHEEL MOUNTING PROCEDURE
MACHINE WHEELS
1. Turn machine off and remove key.
2. Be sure unit is on a level surface. Unhitch from tow vehicle if possible.
3. Block the opposite wheel then the one you are working on.
4. Loosen nuts slightly on wheel to be removed.
5. Jack up machine being careful not to damage underside of machine.
6. Remove nuts, remove wheel.
7. Place new wheel on hub lining up bolt holes.
8. Torque nuts to 64-74 ft/lb (87-100 Nm) using a cross pattern. Torque again after first 10 hours and every
200 hours thereafter.
9. Lower machine to ground and remove blocks and jack.
FILTER SYSTEM
Filter pack may be cleaned by shaking or spraying off with low pressure water. Filter will disintegrate if high
pressure is used on it.
pressure is used on it.