Справочник Пользователя для Smithco Automobile 78-200-A
7
Service
OVERLOADING DEBRIS HOPPER AND WEAR ON VACUUM HOUSING
OVERLOAING DEBRIS HOPPER
Smithco Sweeper-Vacs are designed to carry the following maximum loads:
Model 72-000 Big Vac
1500 lbs. (608 kg)
Model 78-200 & 78-500 Sweep Star V62
860 lbs. (400 kg)
PLEASE NOTE THE FOLLOWING:
1. Loads heavier than that will damage the unit.
2. Such damage is not covered by warranty.
3. Overloading is particularly easy when collecting aerifier cores.
4. The hoppers on the Big Vac and V62 are large in order to hold 7 and 4 cubic yards respectively, of thatch,
grass clippings, leaves and trash.
5. They will not hold 7 or 4 cubic yards of aerifier cores.
6. The maximum depth (in the debris hopper) of aerifier cores is:
Model 72-000 Big Vac
12 in. (30 cm)
Model 78-200 & 78-500 Sweep Star V62
40 in. (101 cm)
VACUUM HOUSING WEAR
The Big Vac & V62 are fitted with a wear resistant liner in the vacuum housing. This will provide additional husing
life. Be sure the following points are explained to the user:
life. Be sure the following points are explained to the user:
1. The vacuum housing and impeller must be cleaned each time the unit is used so the housing liner is
inspected daily. Only Smithco Sweeper-Vacs provide a clean out/inspection port for easy inspection and
cleaning.
cleaning.
2. When bare steel is visible at any point in the housing lining, the lining must be replaced. It is expected the
liner will wear and be replaced. It is a vast improvement over competitive units with no liners.
3. Replacement of the liner or the vacuum housing due ti wear is normal and is not covered by warranty.
4. Collection of aerifier cores causes extreme wear on the liner (and if unchecked, on the housing).
5. Caution users that, while Smithco Sweeper-Vacs do an excellent job collecting cores, the lining (and the
housing) will wear quickly in such use.
RUBBERIZED BOOT
The rubberized boot between main unit and sweeper head is subject to wear and damage from debris. Unless
defecetive, replacement of this boot is not covered by warranty.
defecetive, replacement of this boot is not covered by warranty.
MAXIMUM LOAD CAPACITY
There are decals on each side of the hopper to indicate the maximum depth of aeration cores. The maximum
depth for aeration cores in the hopper is 40" (101 cm). The maximum depth of sand and dirt in hopper is 20"
(50cm). The maximum load capacity of the Sweep Star V-62 is 860 lbs (400 kg).
depth for aeration cores in the hopper is 40" (101 cm). The maximum depth of sand and dirt in hopper is 20"
(50cm). The maximum load capacity of the Sweep Star V-62 is 860 lbs (400 kg).
Overloading will cause damage that is not covered by the warranty.