Справочник Пользователя для Omni Group GREEN SMART 864

© Travis Industries 

4090507 

100-01217_000 

•  Side vent configurations use 8" (203mm) diameter Simpson Dura-Vent Model Direct-Vent Pro (or GS)*. 
•  Top vent configurations use 8" (203mm) or 6-5/8" (168mm) diameter Simpson Dura-Vent Direct-Vent Pro (or 

GS)*. If using 6-5/8" (168mm) diameter vent, attach the 8" (203mm) to 6-5/8" (168mm) reducer (Travis part # 
98900165) to the fireplace. 
NOTE: When using 6-5/8” (168mm) diameter vent, make sure to accommodate the 3” (76mm) clearance 
above the vent for the first 48” (1219mm) of rise (see vent clearances on page 18).  Standard firestops do not 
include this clearance. 
 
* Other vent may be approved with this fireplace.  Check with the vent manufacturer for details. 
 

•  Always use the high-wind cap (or high-wind sconce cap, part # 58DVA-HSCH or 46DVA-HSCH). 
•  Installation instructions for Simpson Dura-Vent may be found at www.duravent.com 

 

6-5/8" (168mm) Diameter Vent

Reducer - # 98900165

 

 

•  Slide the vent sections together and turn 1/4 turn until the sections lock in 

place. 

•  Screws are not required to secure the vent.  However, three screws may be 

used to secure vent sections together if desired. 

•  High temperature sealant is recommended at the appliance starter section 

connection (use high-temperature silicone or Mill-Pac®). 

•  If disassembly is required, at time of re-assembly check to see if the vent 

creates a tight fit.  If it does not, apply high temperature sealant to the joints 
of the affected sections. 

 

•  Horizontal sections require a 1/4" (6mm) rise every 12" (305mm) of travel 
•  Horizontal sections require non-combustible support every three feet (e.g.: plumbing tape)