Справочник Пользователя для Advanced Wireless Solutions EMO-500
AW Company 8809 Industrial Drive, Franksville, WI 53126 à web: www.awcompany.com
Tel: 262-884-9800 Fax: 262-884-9810 | Email: aw@awcompany.com
REV. 4 10/05 EMO-500 Manual.DOC
23
11. Analog Rule
Default 06
The analog rule allows the user to set the analog output to follow any of the variables
listed below. The variable is selected by entering its number as the Analog Rule.
These are:
00 - Flow A
06 - Ratio
01 - Flow B
07 - Ratio Feedback Mode
02 - Flow A+B
08 - Ratio w/Reset
03 - Total A
09 - Ratio Feedback w/Reset
04 - Total B
10 - A - B Job Total
05 - Total A+B
11 - A - B Flow Rate
NOTE: These variables will be used in the computations as numbers in Engineering
Units.(ccpm,gals,ozs.etc.) This means that the Decimal Points, if any, will be dropped
from the numbers.
For instance: 113.7ccpm will be 1137 for computations.
12. Unit Number................................................................................................Default 001
This Variable is used for Serial Communication with a host computer. It will identify
each EMO 500 unit if there is more than one on the communication line. For example -
Unit #1 would be designated 01 & unit #2, 02 ....etc.
Units.(ccpm,gals,ozs.etc.) This means that the Decimal Points, if any, will be dropped
from the numbers.
For instance: 113.7ccpm will be 1137 for computations.
12. Unit Number................................................................................................Default 001
This Variable is used for Serial Communication with a host computer. It will identify
each EMO 500 unit if there is more than one on the communication line. For example -
Unit #1 would be designated 01 & unit #2, 02 ....etc.