Справочник Пользователя для Advanced Wireless Solutions EMO-500

AW Company 8809 Industrial Drive, Franksville, WI 53126  à web: www.awcompany.com 



 Tel:  262-884-9800  Fax:  262-884-9810 | Email: aw@awcompany.com          

REV. 4                                          10/05                                      EMO-500 Manual.DOC

 

 

26

WARNING --- IMPORTANT --- WARNING --- IMPORTANT        

                                                                 
The communication port does not discriminate any addresses. This means that any 
address can be written to as well as read from.  Writing to certain addresses will change 
the operation of the EMO 500 drastically.  Caution is a must when programming 
through a host computer.  Double Check Addresses and Variables   Before Writing to 
the EMO 500 !!                                 

 

 

The EMO 500 has RS-232 and RS-485 serial port connections standard on the back panel 
9 Pin connector.   The user can connect this port to a host computer and then Read or 
Write to any memory location in the EMO 500.   The RS-232 Pins on the 9 Pin connector 
are: 
 
                   Pin 3......TX transmit   
                   Pin 2......RX receive 
                   Pin 5......Ground 
 
The RS-485 connections are: 
 

Pin 6 ..... RX 
Pin 7 ..... TX 
Pin 8 ..... RX* 
Pin 9 ..... TX*

 

 
 

Note: The communication through the serial port will not work if the EMO-500 is in 
programming mode 

Protocol Format 

 

 The EMO 500 uses a protocol format follows OPTOMUX by the OPTO 22 Company. 
 
     The format for reading from the EMO 500 is as follows:  
 
   >01K0F3404XXcr 
   ^................start of string must use the > sign 
    ^^.............unit number (under global variables) 
      ^.............read command K (use J to write) 
       ^^^^......address to read from  
           ^^......number of bytes to read 
             ^^....checksum for the string 01K0F3404 
               ......carriage return (ASCII 13) ends the string