Инструкции По Установке для Gaggenau VI491610

Check appliance for functionality first (see 
section “Check the installation"). 
Fill in the gap between the worktop and the 
ceramic hob using a suitable commercial silicone 
bonding agent in a color of your choice. Please 
observe the manufacturer’s instructions for use. 
Apply the silicone bonding agent in the joints. 
Before the silicone bonding agent starts to form a 
skin, moisten a blade or your finger with a soapy 
solution and smooth it over.
Don't turn on the appliance until after the silicone 
adhesive has completely dried (at least 24 hours, 
depending on room temperature).

9

Unsuitable silicone adhesive will cause natural 
stone countertops to become permanently 
discolored.

Refer to data plate for more information. See "Service" 
for data plate location.

The branch-circuit breakers ampacity, the wire sizes 
and the connections must be conform to the 
requirements of the National Electrical Code or 
Canadian Electrical Code and all local codes and 
ordinances.

Attach flexible conduit to the junction box. Connect 
the lead wires to the junction box supply wires in 
proper phase:

▯

black (L1) to black

▯

red (L2) to red

▯

green or bare to ground

9

Before you plug in an electrical cord or turn on 
power supply, make sure all controls are in the 
OFF position.

Remove everything from the cooktop surface. Clean 
cooktop surface with cooktop cleaning creme.

Switch on the circuit breaker.

Verify that elements function properly.

When the light rings behind the control knobs blink, 
the connecting cable between the control console and 
the appliance isn't plugged in correctly. Disconnect 
the appliance from power and ensure that the 
connecting cable is correctly fitted.

Disconnect the appliance from the power supply. For 
flush-mounted appliances, remove the silicone joint. 
Push out the appliance from below.

9

Damage to appliance! Don't lever device out 
from above at the frame.