Инструкции По Установке для Thermador PH48GS
English 15
Installing Filters, Grease Trays, and Heat Lamps
•
Remove all plastic from hood pieces.
•
Insert in the following order:
1) Grease Tray — Push up and in over the rear lip.
2) Filters — Slide filter over the front lip. Push filter
rear up, then slide back over rear lip.
3) Side Panels — Insert these the same way as the
filters.
Reverse the above directions to remove the grease tray, fil-
ters and side panels (Figure 24).
ters and side panels (Figure 24).
Note:
Depending upon the size and model of hood, there will be
from 1 to 3 filters per hood.
Depending upon the size and model of hood, there will be
from 1 to 3 filters per hood.
Note:
Do not use cooktop while hood is disassembled. Grease
trays must be in place before installing the filters.
Do not use cooktop while hood is disassembled. Grease
trays must be in place before installing the filters.
Heat Lamp Replacement (some models)
•
•
Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
a PAR-40 250W heat lamp.
The PAR-38 175W heat lamp provides a tighter seal within
the enclosure and produces the same amount of effective
heat with lower energy consumption. These lamps may not
be readily available at local retail outlets. The PAR-40
250W heat lamp is more widely available. It can be used
instead.
the enclosure and produces the same amount of effective
heat with lower energy consumption. These lamps may not
be readily available at local retail outlets. The PAR-40
250W heat lamp is more widely available. It can be used
instead.
PAR-38 175W heat lamps can be purchased through the
following retailers:
following retailers:
•
OpTech Inc: 800-848-6624 or
www.optechlightbulbs.com
www.optechlightbulbs.com
•
bulbs.com: 888-455-2800 or www.bulbs.com
Figure 24: Filter Installation
1
1
2
2
Filters
Grease Tray
Side
panel
Side
panel
Figure 25: Heat Lamp Replacement