Thermador PH48GS Installation Instruction

English 15

•

Remove all plastic from hood pieces.

•

Insert in the following order:

1) Grease Tray — Push up and in over the rear lip. 

2) Filters — Slide filter over the front lip. Push filter 

rear up, then slide back over rear lip.

3) Side Panels — Insert these the same way as the 

filters.

Reverse the above directions to remove the grease tray, fil-
ters and side panels (Figure 24). 

Note:
Depending upon the size and model of hood, there will be 
from 1 to 3 filters per hood.

Note:
Do not use cooktop while hood is disassembled. Grease 
trays must be in place before installing the filters. 

•

Turn heat lamp clockwise to install (Figure 25). 

•

Replace lamp with either a PAR-38 175W heat lamp or 
a PAR-40 250W heat lamp. 

The PAR-38 175W heat lamp provides a tighter seal within 
the enclosure and produces the same amount of effective 
heat with lower energy consumption. These lamps may not 
be readily available at local retail outlets. The PAR-40 
250W heat lamp is more widely available. It can be used 
instead. 

PAR-38 175W heat lamps can be purchased through the 
following retailers: 

•

OpTech Inc: 800-848-6624 or 
www.optechlightbulbs.com

•

bulbs.com: 888-455-2800 or www.bulbs.com