Справочник Пользователя для Invacare Adjustable ASBA Seat

SECTION 6—FRONT RIGGINGS

70° Taper

NOTE: For this procedure, refer to
FIGURE 6.2

1. Turn the footrest to the side (open

footplate is perpendicular to
wheelchair).

2. Insert footrest mounting pin into

mounting tube.

3. Push the footrest towards the inside of

the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the
wheelchair when locked in place.

FIGURE 6.2 Installing/Removing Footrests -

4. Repeat STEPS 1‐ 3 for the other footrest assembly.

5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.

Adjusting the Footrest Height

WARNING

Minimum ground clearance for the footrest is three inches - otherwise personal
injury or damage may result.

PH904A and PHAL4A Front Riggings

NOTE: For this procedure, refer to
FIGURE 6.3.

1. Loosen, but DO NOT remove, the lug

bolt and locknut that secure the lower
footrest to the footrest support.

2. Reposition the lower footrest to the

desired height.

3. Securely tighten the lug bolt and

locknut that secure the lower footrest to
the footrest support.

4. Repeat STEPS 1‐3 for the opposite side

of the wheelchair footrest if necessary.

FIGURE 6.3 Adjusting the Footrest Height

Footrest

Mounting Pin

Footrest

Release

Lever

Footplate

Mounting Tube

Footrest

Support

Lug Bolt

Locknut

Lower Footrest

NOTE: PH904A style front rigging
shown. PHAL4A front rigging adjust
the same way.