Справочник Пользователя для Emerson Process Management 3420
88
DHCP server switch settings
Section 3: Installation
Reference, Installation, and Operations Manual
June 2013
3-9000-743 Rev S
3.5.7
DHCP server switch settings
The meter can be configured to act as a DHCP server (
for further details). The
DHCP server is enabled/disabled via CPU Board switch S2 position 2 as follows:
3.5.8
Configuration protection switch settings
The meter’s configuration parameters and firmware can be protected against changes via CPU
Board switch S2 position 4 as follows:
Board switch S2 position 4 as follows:
A complete reference of write-protected parameters are listed in
. Also
3.6
Security seal installation
The following sections detail how to properly seal the ultrasonic meter after commissioning. Be
sure to set Switch S2 - Position 4 on the CPU board to the
sure to set Switch S2 - Position 4 on the CPU board to the
OPEN
position prior to sealing the
enclosure (to write-protect the meter’s configuration).
Table 3-47 DHCP server settings
CPU Board Switch
DHCP Server Disabled
DHCP Server Enabled
S2-2
OPEN
CLOSED
Table 3-48 CPU configuration protection switch
CPU Board Switch
Configuration Protected
Configuration Unprotected
S2-4
OPEN
CLOSED