Alliance Laundry Systems 907003062 用户手册

Adjustments

70420801 (EN)

Airflow Switch

The airflow switch is set at the factory for proper

operation. No adjustment necessary.
The airflow switch operation may be affected by

shipping tape still in place, lack of make-up air, or an

obstruction in the exhaust duct. These should be

checked and the required corrective action taken.

IMPORTANT: Airflow switch vane must remain

closed during operation. If it opens and closes

during the drying cycle, this indicates insufficient

airflow through the tumble dryer. If switch remains

open, or pops open and closed during the cycle, the

heating system will shut off. The cylinder and fan

will continue to operate even though the airflow

switch is indicating insufficient airflow.

NOTE: To properly mount the airflow switch

bracket, or in case of a load not drying, the airflow

switch bracket may need to be checked for proper

alignment. Be sure the locator pins are securely in

their respective holes before tightening the bracket

mounting screws. This will assure proper

alignment of the airflow switch arm in the channel

of the airflow switch bracket and prevent binding

of the arm.

Loading Door Strike

The loading door strike must be adjusted to have

sufficient tension to hold loading door closed against

force of load tumbling against it. Proper adjustment is

when 8-15 pounds (35.6-66.7 N) pull is required to

open door.
If adjustment is required, refer to Figure 17 and

proceed as follows:
To adjust, open door, loosen jam nut and turn door

strike screw in or out as required. Retighten jam nut.

Figure 17

Loading Door Switch

Loading door switch is factory set; no field adjustment

necessary.

WARNING

The tumble dryer must not be operated if

the airflow switch does not operate

properly. Faulty airflow switch operation

may cause an explosive gas mixture to

collect in the tumble dryer.

W072R1

T048I

Door Strike

Door Latch

Jam Nut