American Dryer Corp. WDA-385 用户手册

F. "dOOr" Display Condition

When the display reads "dOOr," this indicates that there is a fault (open circuit) somewhere in the

microprocessor controller's door switch circuit. Includes the door switch, microprocessor controller and

the wires to and from these two (2) points. Before following this test procedure, check the component

side of the computer to see if L.E.D. input light is on. If on, replace computer. Voltage is 24VAC unless

otherwise specified.

1. Remove door switch assembly from dryer. Check for

continuity across the two (2) terminals of the door switch

with plunger pushed in. If no continuity, replace the door

switch. If continuity is evident, reassemble door switch

back on dryer.

2. Make sure main door is closed and the plunger of the door

switch is pushed in. Check for voltage across TB #5 and #7.

If no voltage is evident, problem could be faulty transformer

(P/N: 141403) or bad wire or termination in the door switch

harness, from door switch to terminal block.

2. Check for voltage across microprocessor's 15-pin

connector #2 (yellow wire), and the spade terminal

on the microprocessor marked GND. If no voltage,

problem is bad wire or termination in wire from

microprocessor connector #2 to TB #5. If voltage,

problem is faulty computer.