Heath Zenith SL-5514 用户手册

2

For easy installation, select an existing light operated 
by a wall switch for replacement.
For best performance, mount the fixture about 8 ft. 
(2.4 m) above the ground.

❒

 

Turn power off at the fuse or circuit breaker. 

❒

  Remove the existing light fixture.

❒

  Install mounting strap to junction box using screws 

appropriate for your junction box.

❒

  The plastic hanger can be used to hold the fixture 

while wiring. The small end of the plastic hanger 
can be threaded through the hole in the center of 
the cover plate. The small end then goes into one 
of the slots on the mounting strap.

❒

  Thread all fixture wires through the large holes in 

the gasket as shown.

❒

  Connect the junction box wires to the light fixture 

wires as shown. Twist together and secure with wire 
connectors.

For eave mount only:

For under eave installation, the sensor head must 
be rotated as shown in the next two steps for proper 
operation and to avoid the risk of electrical shock.

❒

  Place  the  mounting  bolt  through  the  front  of  the 

junction box cover.

❒

  Make sure the wire connectors and wires are inside 

the junction box. Align the mounting screw with the 
center hole in the mounting strap. Secure the fixture 
to the mounting strap.

❒

  Push the rubber plug firmly into place.

❒

  If not installed on a weatherproof box, 

wall plate and mounting surface with silicone.

Keep lamps at least 1" (2.5 cm) 
from the sensor. 

Black to Black

White to White

Gasket

Connect any fixture ground wire(s) and the cover plate 
ground screw to the junction box ground wire.

•  Allow fixture to cool before touching. The bulb and 

the fixture operate at high temperatures.

•  Keep fixture at least 1" (2.5 cm) from combustible ma-

terials. Do not aim at objects closer than 3 ft. (1 m).

•  Use only T3, 150W (max.) tungsten halogen 120 

VAC lamps.

Rubber 

Plug

Mounting Bolt

NOTE: When re-lamping, turn power off and let the 
fixture cool.
❒

  Open glass covers. To remove the old bulb push the 

bulb towards the right (with fixture as shown) until 
the left side of the bulb is clear of the left socket.

❒

  To install a bulb, push the bulb into the right socket 

so the bulb fits completely into the left socket.

❒

  Check that the bulb is seated properly.

❒

  Close the glass covers.

Push the Rubber Plug over 
the mounting screw.

❒

Adjust the lamp holders by loosening the lock nuts 
but do not rotate the lamp holders more than 180° 
from the factory setting.

❒

 Rotate the sensor head towards the clamp screw 

joint.

❒

 Then rotate the sensor head clockwise 180° so the 

controls face down.

Control Switch

Joint Clamp

If  the  sensor  pops  out  of  the  ball  joint,  loosen  the 
clamp screw and push the sensor back into the ball 
joint. Tighten the clamp screw when done.