Heath Zenith SL-5514 用户手册
3
595-5730-05
The detector is less sensitive to motion directly towards
it and more sensitive to across motion.
it and more sensitive to across motion.
Least Sensitive
Most Sensitive
Sensor
Motion
Motion
Avoid aiming the sensor at:
• Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
sources could cause false triggering.
• Areas where
pets or traffic may trigger the control.
•
Nearby large, light-colored objects reflecting light
may trigger the shut-off feature. Do not point other
lights at the sensor.
may trigger the shut-off feature. Do not point other
lights at the sensor.
60 ft.
(18.3 m)
8 ft.
(2.4 m)
Maximum Range
Maximum
Coverage Angle
110°
NOTE: Sensor has about 1
1
/
2
minutes warm up period
before it will detect motion. When first turned
on, wait about 1
on, wait about 1
1
/
2
minutes.
SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 60 ft. (18.3 m) [varies with
surrounding temperature].
Sensing Angle . . . . . . . Up to 110°
Electrical Load . . . . . . . 300 watt Incandescent [150
Electrical Load . . . . . . . 300 watt Incandescent [150
Max each lamp holder].
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
Operating Modes . . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . . 1, 5, 10 minutes
Replacement lamp . . . . T3 150W halogen maximum
Replacement lamp . . . . T3 150W halogen maximum
120 VAC
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
❒
Loosen the clamp screw in the
sensor ball joint and gently
rotate the sensor.
rotate the sensor.
❒
Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area.
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cover-
age area.
Keep the sensor at
least 1" (2.4 cm) away from
the lamps.
the lamps.
❒
Adjust the SENSITIVITY as
needed. Too much sensitivity
may increase false triggering
may increase false triggering
❒
Secure the sensor head’s
aim by tightening the clamp
screw. Do not overtighten the
screw.
aim by tightening the clamp
screw. Do not overtighten the
screw.
❒
Set the amount of TIME you
want the lights to stay on after motion is detected
(1, 5, or 10 minutes).
(1, 5, or 10 minutes).
TEST AND ADJUSTMENT
❒
Turn on the circuit breaker and light switch.
❒
Turn the SENSITIVITY (SENS) control to the mid
position and the ON-TIME control to the TEST
position.
position.
Bottom of Sensor
ON-TIME
10 5 1 TEST
MIN MAX
SENS
Clamp
Screw
Screw
Ball
Joint
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage