Regency U41-LP3 用户手册

Regency U41-3 ULTIMATE Gas Fireplace Insert

1) Open the two side doors.

2) Slide the door onto the two hinge pins

making sure the two pieces are flush to-
gether.  See diagram 1.

3) Place the left front log, carefully sliding it

down onto the left pins of the front burner.
See diagram 2.

4) Place the right front log, carefully sliding  it

down onto the right pins of the front burner.
See diagram 3.

5) Distribute the embers along the front burner

but do not cover the burner ports and
around the logs. Place the large embers on
the floor of the firebox. Place the lava on the
burner tray in front of the left and right front
logs. See diagram 4.

The gas log kit contains the following:

a) Front Right Log - Part # 902-245
b) Front Left Log - Part # 902-244
c) Rear log - Part # 902-246
d) Embers - Part # 902-151 (2 bags)

Lava - Part # 902-154 (1 bag)

(Part # 653-930 for the set of three logs)

1) Remove the logs from the box and carefully

unwrap them. The logs are fragile, handle
with care - DO NOT FORCE into position.

2) Place the rear log, carefully sliding it down

onto the pins, with the flat side of the log
facing the back of the unit. See diagram 1.

3) Close the door. The latch plate must be

centered around the alignment pin.  See
diagram 2.  If the latch plate interferes with
the corner of the stove you may want to
angle the plate slightly so the door closes
more easily.

4) The latches should already be at the proper

setting.  If they are too hard or too easy  to
close,  you may want to adjust them by
turning the latch.  See diagram 3.

5) Remove the blue plastic protective coating.

6) Test the seal around the door by placing a

piece of paper between the unit and the
door, close the door and try to pull the paper
out. If it slips out easily, then the door is not
p r o p e r l y
sealed. Turn
the adjustable
catch to tight-
en or loosen the
latch.  See diagram 3.