Regency Wraps P36-LPG4 用户手册
Regency
®
P36-4 Gas Log Fireplace
21
OPTIONAL
BRICK PANELS
1) Undo the bottom 2 door latches and open
and remove glass door. Remove logs.
Note: The logs must not be in the unit.
2) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the
fi rebox and the rear log bracket.
fi rebox and the rear log bracket.
4) Light the pilot and turn the valve to "ON"
position.
5) The pressure check should be carried out
with the unit burning and the setting should
be within the limits specifi ed on the safety
label.
be within the limits specifi ed on the safety
label.
6) When fi nished reading manometer, turn
off the gas valve, disconnect the hose and
tighten the screw (clockwise) with a 1/8" fl at
screwdriver. Note: Screw should be snug,
but do not over tighten.
tighten the screw (clockwise) with a 1/8" fl at
screwdriver. Note: Screw should be snug,
but do not over tighten.
S.I.T. VALVE DESCRIPTION
1) Gas
on/off
knob
2) Manual high/low adjustment
3) Pilot
3) Pilot
Adjustment
4) Thermocouple Connection - option
5) Outlet Pressure Tap
6) Inlet
5) Outlet Pressure Tap
6) Inlet
Pressure
Tap
7) Pilot
Outlet
8) Main Gas Outlet
9) Alternative
9) Alternative
TC
Connection
Point
3) Put the side panels in next. Slide them in
from the front and push them fl at up against
the wall. Be very careful not to scratch them
on the fi rebox hardware.
the wall. Be very careful not to scratch them
on the fi rebox hardware.
4) Install the 2 brick retaining clips, one on
each side.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit (Part # 512-930) contains the
following pieces:
following pieces:
a) 02-49 Rear
Log
b) 02-55 Middle Left Log
c) 02-50 Front Left Log
d) 02-53 Center
c) 02-50 Front Left Log
d) 02-53 Center
Left
Log
e) 02-51 Front Bottom Log
f) 02-54 Center
f) 02-54 Center
Right
Log
g) 02-52 Middle Right Log
h)
h)
Embers
902-156
i)
Vermiculite 902-179
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
with care - do not force into position.
2) Sprinkle the vermiculite around the fi rebox
base.
Vermiculite
Vermiculite
Vermiculite
The "02" refer numbers (i.e. 02-49) are
molded into the rear of each log.
3) Place the Log 02-49 on the rear log support
pins with the fl at side to the back.
INSTALLATION