Carson SA-400-17 用户手册

下载
页码 12
Page 10 of 12     SA-400-17  Installation and Operating Instructions
 
08/06/08 
CP5012A 
 
SERVICE 
This unit is designed to provide years of reliable service under even the worst conditions.  Many 
times there may appear to be a problem with the unit when the true problem is in the speaker(s) 
or improper installation.  The following chart shows typical symptoms and possible causes. 
A blown rear panel fuse doesn't necessarily mean that the unit is bad.  If a speaker or speaker 
lead is shorted this fuse will blow before the unit is damaged.  Disconnect the SPKR leads and 
replace the fuse.  If the siren emits a sound when in the Yelp position it is OK.  Check the speaker
(s) or leads for possible shorting. 
 
PROBLEMS 
 
 
 
 
 
See www.carsonsirens.com for additional information. 
or contact our Service Department at: 
E-mail   service@carsonsirens.com   or   Phone  (888) 577-6877 
 
Symptom 
Possible Cause 
Check 
No power or siren 
output 
Power switch not turned on 
Bad speaker(s) 
Connector loose 
Fuse blown 
Loose connection at power source 
Does backlighting come on? 
Do you hear a "pop" when turned on? 
With siren on, yelp selected, listen for tone in amplifier. 
Is an external fuse or circuit breaker used? 
Are the negative leads connected to a good ground? 
No siren tone - 
PA works 
High Voltage Protection 
Mic button stuck 
Input voltage must be less than highest rated voltage. 
Does mic button release properly? 
No PA 
PA volume not set properly 
Selector in Radio position 
Have you tried turning the PA volume control? 
PA is not available in the Radio position 
Distorted siren 
sound 
Speaker assembly loose 
Intermittent Aux Input connection 
Low vehicle voltage 
Is the speaker bell or tip loose? 
Is the Aux Input used and wired properly? 
Input voltage must be greater than lowest rated voltage. 
Intermittent siren 
tone 
High Voltage Protection 
Connector loose 
Bad power connection 
Mic button activation 
Circuit breaker in supply connection 
Is the vehicle voltage regulator working properly? 
Is the connector tight on the back of the unit? 
Is there a loose connection on a power lead? 
Is something lying on the microphone? 
Is a circuit breaker used with at least a 50A rating? 
Horn function  
Or Manual stuck 
on 
Siren switch stuck 
Aux Input improperly connected 
Does the Siren switch return fully when released? 
Is the Aux Input used and wired properly? 
Aux Input is activated with positive or negative. 
No Radio 
Unit not connected to radio 
Radio volume too low 
Is the radio connected properly to the unit? 
Can you here the radio in the vehicle? 
Have you tried turning the RAD volume control? 
Wrong siren tone  Two-Tone option installed 
Is the T-T option switch turned on?