Yamaha TX6n 用户手册

 

• For details, refer to the TX6n/5n/4n Reference Manual.

 

*Scene..........The settings listed above, such as power Standby/On or mute (with the exception of UTILITY), are called a “scene”. By recalling a scene, the 

saved settings can be immediately applied to the amplifiers.

NOTE

 

METER

ANA INPUT VOLTAGE

Shows the input level from the analog input connectors.

SLOT INPUT VOLTAGE

Shows the input level from the slot.

SP OUTPUT VOLTAGE

Shows the output level from the [SPEAKERS] connectors.

SP OUTPUT POWER

Shows the output power from the [SPEAKERS] connectors.

SP OUTPUT IMPEDANCE

Shows the output impedance from the [SPEAKERS] connectors.

SLOT OUTPUT METER

Shows the output level to the slot.

THERMAL

Shows the heat sink temperature.

UTILITY

Device Setup

Makes settings to distinguish the amplifier on a network.

Word Clock Setup

Sets the word clock.

Information

Shows information about the amplifier.

Network Setup

Specifies the IP address and other settings for using the amplifier in a net-
work.

LCD Setup

Specifies the display settings.

Front Panel Operation

Turns panel operation lock on/off.

Scene Setup

Makes scene* settings.

Misc Setup

Sets the amplifier’s internal clock, etc.

MENU

General

Sensitivity/Amp Gain

Sets the input sensitivity/gain.

Stereo/Bridge/Parallel

Specifies the amplifier’s mode (Stereo/Bridge/Parallel).

Attenation Link

Specifies whether attenuator operation will be linked between channels A 
and B.

Input Redundancy

Specifies the redundant connection mode, etc.

Signal Path

Makes settings for the equalizer, delay, crossover, and others that process 
the audio signal. Speaker Processor libraries can also be recalled.

Signal Chain

Analog Input Signal Chain

Makes settings for checking whether the audio signal is being correctly 
input from the analog connectors.

Slot Input Signal Chain

Makes settings for checking whether the audio signal is being correctly 
input from the slot.

Output Signal Chain

Makes settings for checking the status of output from the [SPEAKERS] 
connectors.

Calibration

Calibrate by Pilot Tone

Uses a pilot tone to measure the impedance of the connected speakers.

Calibrate by Program 
Source

Uses an audio signal to measure the impedance of the connected speak-
ers.

Limiter

Voltage Limiter

Makes settings for the limiter.

Power Limiter

Limiter Gain Reduction

Specifies whether the limiter will be linked between channels A and B.

SCENE

Recall

Recalls a scene*.

Store

Stores a scene*.

Edit

Edits a scene*.

Clear

Clears a scene*.