Acesonic UHF-2932 用户手册

Charging the Microphones

Inserting the rechargeable microphone batteries:

• Grip the upper portion of the microphone with one
hand and twist the lower portion (battery housing
cover) counter-clockwise until it fully unscrews. Slide
it off and place it to the side. Th

e battery compart-

ment gate is now visible. With your thumb and
forefi nger, go over the curved grips, pull the gate open
and out. It should pivot on its hinge at the lower end.

• Place two AA Ni-Mh rechargeable batteries into
the battery compartment spaces provided. Press the

batteries fi rmly to make sure that they have clicked
into place. Snap the battery compartment gate shut.
Screw the battery housing cover back on.

Using the charging station:

• Plug the AC power adapter cord jack into the
matching power socket on the rear of the charging
station. Plug the AC adapter into an AC outlet.

Microphone Description

How to IR Sync

• Make sure microphone is On.

• Select a desired channel on the receiver.

• Push the receiver’s power button once.
Th

is will make the channel blink on the LCD

display panel.

• Position the bottom of the desired microphone so
it faces the IR Sync sensor.

• Press the On/Mute button once on the microphone
to sync.

• RF indicator bar on the LCD display should be full,
and AF bar should respond to any microphone
check.

Your microphone and receiver are now fully sync’ed.

1 Microphone cartridge

2 Transmission antenna

3 Operating indicator light (Green means
power is on & working, yellow means power
is on & muted.)

4 On/Mute button

5 Battery compartment: Th

is is the base of the

microphone where you would hold it, as well as
the device’s battery cover.

6 IR signal receiving & charging unit.