Raritan Computer EMX2-111 用户手册
Chapter 2: Installing and Configuring the EMX Device
34
Note: If you are using a 12V Feature Port X-Cable to connect an
asset management sensor (AMS) to the EMX-111, the SENSOR port
on the device is already being used. Plug the other end of the
Raritan provided phone cable into the Sensor connector on the 12V
Feature Port X-Cable instead of the SENSOR port on the EMX-111.
asset management sensor (AMS) to the EMX-111, the SENSOR port
on the device is already being used. Plug the other end of the
Raritan provided phone cable into the Sensor connector on the 12V
Feature Port X-Cable instead of the SENSOR port on the EMX-111.
2. Connect Raritan environmental sensors to any of the four OUT ports
on the hub.
Raritan sensor hubs CANNOT be cascaded so at most a sensor hub
can be connected to each SENSOR port on the EMX device. This
diagram illustrates a configuration with a sensor hub connected.
can be connected to each SENSOR port on the EMX device. This
diagram illustrates a configuration with a sensor hub connected.
The EMX device
Raritan-provided phone cable
Raritan PX sensor hub
Raritan environmental sensors
3. If there are any Raritan air flow sensors attached, make sure that
sensor faces the source of the wind (such as a fan) in the
appropriate orientation as indicated by the arrow on that sensor.
appropriate orientation as indicated by the arrow on that sensor.
4. Configure the environmental sensor. See
Configuring
Environmental Sensors
(on page 172).