3M MP8660 用户手册
ENGLISH
12
3M 1997
3M
Multimedia Projector MP8660
4-2. Projector Control Panel
Indicator Lamps
The projector control panel (Figure 4-1) has several indicator lamps that illuminate to indicate normal
operation and when alarm conditions have been detected. Refer to the chart below for details.
operation and when alarm conditions have been detected. Refer to the chart below for details.
Normal Operation Indicator Lamps
LED
Status of the Unit
Main Power: ON
STANDBY/ON: ON
Lamp: OFF
Lamp: OFF
STANDBY/ON: ON
Lamp: ON
Lamp: ON
Receiving Remote
Control Signal
Control Signal
POWER
Amber
GREEN
GREEN
REMOTE
OFF
OFF
OFF
Blinking GREEN
CHANGE LAMP
OFF
OFF
OFF
COVER
OFF
OFF
OFF
FAN
OFF
OFF
OFF
TEMP
OFF
OFF
OFF
LAMP
OFF
Blinking GREEN
GREEN
Alarm Indicator Lamps
LED
Status of the Unit
Lamp Failure
Temperature
Failure
Right Panel
Open
Lamp Life Over
(>1000 hours)
Fan Failure
POWER
Amber
Amber
Amber
GREEN
Amber
REMOTE
CHANGE LAMP
RED
COVER
RED
FAN
RED
TEMP
RED
LAMP
RED
Special/Reset Buttons
Press the SPECIAL button (Figure 4-1) to view the
firmware revision level and the current input data
(RGB or Video) for the projector. The TEST
SCREEN (Figure 4-2) will display. If no input is
detected, the message “NO INPUT” will display.
firmware revision level and the current input data
(RGB or Video) for the projector. The TEST
SCREEN (Figure 4-2) will display. If no input is
detected, the message “NO INPUT” will display.
RGB1
TEST SCREEN
TEST SCREEN
FIRMWARE REV
#10011A
SVGA56
H xx.x kHz
V xx.x Hz
#10011A
SVGA56
H xx.x kHz
V xx.x Hz
VIDEO1
TEST SCREEN
TEST SCREEN
FIRMWARE REV
#10011A
NTSC
#10011A
NTSC
Figure 4-2. Test Screens
Press the RESET button (Figure 4-1) to reset all
projector settings to the factory default. Press the
down arrow to change to YES (Figure 4-3) and press
the SELECT button. Press the SELECT button again
to activate the settings and the message “RESET
COMPLETE will display.
projector settings to the factory default. Press the
down arrow to change to YES (Figure 4-3) and press
the SELECT button. Press the SELECT button again
to activate the settings and the message “RESET
COMPLETE will display.
RESET
ALL SETTINGS TO
FACTORY DEFAULT
FACTORY DEFAULT
NO
YES
YES
Figure 4-3. Reset Screen