KitchenAid 400 用户手册

8

Your mixer is adjusted at the factory so that the flat beater just clears the
bottom of the bowl. If for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, clearance can be corrected as follows:

Bowl, flat beater and dough hook
may be washed in an automatic
dishwasher. Or, clean them

thoroughly in hot sudsy water and
rinse completely before drying. Wire
whip should be hand washed and
dried immediately. Do not wash wire
whip in a dishwasher.
NOTE: Always be sure to unplug
Stand Mixer before cleaning. Wipe
Stand Mixer with a soft, damp cloth.
Do not use household/commercial
cleaners. Do not immerse in water.
Wipe off beater shaft frequently,
removing any residue that may
accumulate.

1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect

power.

3. Unlock motor head.
4. Tilt motor head back and lock.
5. Remove bowl, beater, dough

hook, or wire whip if attached.

6. Turn screw (A) slightly

counterclockwise (left) to raise the
flat beater, or clockwise (right) to
lower flat beater.

7. Attach flat beater and bowl.

8. Unlock motor head and lower.

9. Beater should just clear surface of

bowl. If it does not, repeat steps
4-7.

NOTE: If you over adjust the screw,
the bowl lock lever may not lock into
place.
NOTE: When properly adjusted, the
flat beater will not strike on bottom
or side of bowl. If beater or wire whip
is adjusted too close so that it strikes
bottom of bowl, coating may wear
off beater or wires may wear through
on wire whip.