GE PVB67 用户手册

Skip this step if there is no separate control switch.

• Connect the mating wire ends.
• Place the adhesive wire clamps (provided) near 

the mating connector.

• Keep approximately 3"-long wire and attach  

the wire to the clamp with a wire tie. This will act 

as a strain relief.

• Drill a 1/2"-dia. hole into the desired location.  

Use the mounting bracket as a template to locate 

the hole accurately. Check for interference  

between the switch cover, adjacent objects  

and cooktop/vent overlaps.

• If switch is mounted into a tile surface, drill the hole 

between tiles. Use locally approved caulking to 

cover any gaps.

• Thread the remote harness through the 1/2"-dia. 

hole and attach the harness connector to the 

remote connector.

• Remove the paper backing on the foam piece 

and mount the remote trim on the countertop 

such that the switch connectors stay located  

in the 1/2"-dia. hole.

• Stick adhesive wire clamp near the 1/2"-dia. hole 

and attach the loose wire with a wire tie.

Disconnect electrical power from unit before  

beginning switch installation. Failure to do so could 

result in personal injury or damage to the electrical 

controls.

Determine the location for the control switch.  

The wiring lead is 68" long.

Control 

Box

1/2"-Dia.  

Hole

Foam Piece With Adhesive 

Mounting Surface

Remote Switch

Strain Relief  

(Adhesive wire clamp  

with tie)

Remote Harness

Remote Harness

Mating Connectors

Strain Relief  

(Adhesive wire clamp 

with tie)