Raymarine D7637-1 用户手册
User Guide
25
Fault finding
All Raymarine products are designed to provide many years of trouble-free
operation. We also put them through comprehensive testing and quality
assurance procedures before shipping.
operation. We also put them through comprehensive testing and quality
assurance procedures before shipping.
If a fault occurs with your S1000, use the fault finding tables in this section
to help identify the problem and provide a solution. If you cannot resolve the
problem yourself, refer to the product support information.
to help identify the problem and provide a solution. If you cannot resolve the
problem yourself, refer to the product support information.
SYMPTOM
POSSIBLE CAUSE and SOLUTION
Display is blank
No power – press standby to power up the S100
or change the batteries.
or change the batteries.
Autopilot not responding.
Drive the boat for 30 seconds at above 2.5kts and
retry.
Check autopilot connections.
Check GPS is switched on and connected.
retry.
Check autopilot connections.
Check GPS is switched on and connected.
Boat turns slowly and takes a
long time to come onto course
long time to come onto course
Rudder gain too low. Increase gain setting.
Boat overshoots when turning
onto a new course
onto a new course
Rudder gain too high. Decrease gain setting.
Position information not
received
received
Navigator not transmitting the correct position
data.
data.
The pilot will not auto advance
to the next waypoint.
to the next waypoint.
No bearing to waypoint information received from
the navigator.
the navigator.
Instruments powered from
SeaTalk will not power up
SeaTalk will not power up
Check connections
Check fuses
Check fuses
81245_4.book Page 25 Monday, April 30, 2007 6:03 PM