Quantum acl 4 安装指导

 Chapter 2 Unpacking the Library

Removing Internal Packing and Inserting Tape Cartridges

ACL 4/52 Facilities Planning and Installation Guide

11

Removing Internal Packing and 
Inserting Tape Cartridges

2

Once the library is in the final installation site, you must remove 
internal packing materials and install any available tape cartridges as 
explained in this section. The following are major steps in this 
procedure:

•

Removing the left cosmetic panel

•

Removing tie-wraps

•

Removing foam blocks

•

Inserting tape cartridges

•

Reinstalling the cosmetic panels

Make sure the library is at its final installation site before 
removing the internal packing materials. Damage to the 
equipment may occur if the library is moved without the 
internal packing materials in place.

2

To remove the left cosmetic panel:

1 At the back of the library, remove the three screws that secure the 

left panel to the library frame (see figure 10).

2 Pull the panel toward the back of the library to disengage the 

retention tabs on the left side of the library frame and then take the 
panel away from the library frame.

3 Set the left panel and the screws aside.