KitchenAid kudd03dtpa 安装指导
4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts needed
Parts Supplied
Check that all parts are included.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
■
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
installed to meet all electrical and plumbing national and local
codes and ordinances.
■
Install the dishwasher as specified in these instructions.
■
Have everything you need to properly install dishwasher.
■
Keep the dishwasher and water lines leading to dishwasher
from freezing. Damage from freezing is not covered by the
warranty.
from freezing. Damage from freezing is not covered by the
warranty.
■
This dishwasher is manufactured for indoor use only.
■
Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
and in an area suitable for its size and use.
■
Pliers
■
Phillips screwdriver
■
Flat-blade screwdriver
■
³⁄₁₆" and ¼" (0.4 cm and
0.6 cm) nut drivers or hex
sockets
sockets
■
Measuring tape or ruler
■
1½" (3.81 cm) hole saw
bit
bit
■
10" (25.4 cm) adjustable
wrench
wrench
■
Utility knife
■
Level
■
Cordless drill
■
¹⁄₈" drill bit
■
Security T-20 TORX
®†
driver (if installing custom
front panels)
front panels)
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
B. Zip tie
C. 2 appropriate sized UL listed wire connectors
D. Handle (if installing custom front panels)
D. Handle (if installing custom front panels)
E. Overlay panel (if installing custom front panels)
A
B
C
D
E
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
A.
³⁄₄
" (1.9 cm) UL listed strain
relief
B. 1.25" (3.1 cm) hose clamp
C. 8 mounting bracket screws
D. 4 unit mounting screws
D. 4 unit mounting screws
E. Drain hose connector
F. 4 mounting brackets
F. 4 mounting brackets
G. Drain connector spring
clamps
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws
K. Toe kick trim
L. 2 panel fasteners (on some
models)
M. 10 TORX
®†
screws (on some
models)
N. Drain hose
A
B
C
D
E
F
H
G
I
J
K
L
M
N