Frigidaire fgef304dk 用户手册

3

Where local codes does NOT permit connection of the frame 
grounding conductor to the neutral wire of the copper power 
supply cord (see Figure 4):

1.  Remove the screws from the access plate at the lower right 

end of the rear cover to expose range terminal connection 
block.

2.  Remove the grounding strap from the terminal block and 

from the appliance frame. 

3.  Using the nuts supplied with the literature package, 

connect the ground wire (green) of the copper power 
supply cord to the frame of the appliance with the ground 
screw, using the hole in the frame where the ground strap 
was removed (see Figure 4).

4.  Connect the neutral of the copper power supply cord to 

the center silver-colored terminal of the terminal block, 
and connect the other wires to the outer terminals. Match 
wires and terminals by color (red wires connected to the 
right terminal, black wires connected to the left terminal).

5.  Replace the terminal cover and replace the screws.

Terminal Block

Silver Colored Terminal 

Red

Wire

Neutral 

(White Wire)

Ground (Bare 

Copper Wire)

To 240 V Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at This 

Location

Black Wire

1 1/8" (2.9cm) 

Dia. Direct 

Connection 

Hole. Punch 

Out Knockout 

for 1 3/8" 

(3.5cm) Dia. 

Cord Kit Hole.

NOTE: Be sure to remove the 

supplied grounding strap.

If local codes permit connection of the frame grounding 
conductor to the neutral wire of the copper power supply cord 
(see Figure 3):

1.  Remove the screws from the access plate at the lower right 

end of the rear cover to expose range terminal connection 
block.

2.  Using the nuts supplied in the literature package, connect 

the neutral of the copper power supply cord to the center 
silver-colored terminal of the terminal block, and connect 
the other wires to the outer terminals. Match wires and 
terminals by color (red wires connected to the right 
terminal, black wires connected to the left terminal) (see 
figure 3).

3.  Replace the terminal cover and replace the screws.

Silver Colored Terminal

1 1/8" (2.9 cm) Dia. 

Direct Connection 

Hole. Punch Out 

Knockout for 1 3/8" 

(3.5 cm) Dia. Cord 

Kit Hole.

To 240 V 

Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at This 

Location.

Black 

Wire

Terminal

Block

Neutral 

(White Wire)

Grounding

Strap

Red Wire