3M scp716w 安装指导

Assembly and Installation Guide 

3M™ SCP700 Series Mobile Stand

 

The following steps should be performed by two people.

Step 1.  Lay the base on the ground with the support poles attached.

Step 2.  Line up the support poles with the matching holes that are 

located at the bottom of the back support assembly.

Step 3.  Slide the back support assembly onto the support poles.

Step 4.  Slide the unit forward until the gas shock bracket is resting 

on the base between support poles.

Step 5.  Use a rubber mallet to gently hammer the gas shock base 

into place between the support poles (Figure A).

Step 6.  Gently tilt the unit upright until it is resting on the base with all 

four caster wheels touching the ground.

Step 7.  Install the Back Plate.  Use screws M6 x 20mm to secure 

plate.  The plate has 3 letter markings A, B, and C.  Align 

holes and install four screws.  Key: A=Model SCP716, 

B=Model SCP712, C=Model SCP715/717/740.

Step 1.  Remove the two (2) M10 x 35mm set screws in the 

base columns.

Step 2.  Place the two (2) support poles onto the base 

columns. 

Step 3.  The cable ports of the support poles must face the 

back of the base, exposing the base columns and 

set screw mounting points.

Step 4.  Once the support poles are seated firmly, install 

and tighten  the two (2) M10 x 35mm set screws 

found on the bottom rear of the base columns to 

secure the support poles to the base.

B

C

716

712

715/717/740