3M scp716w 安装指导

© 3M 2010.  All Rights Reserved. 

3M™ SCP700 Series Mobile Stand 

Assembly and Installation Guide

Step 4.  Using a Phillips (+) screwdriver, remove

the three screws holding the cover to 

the base.

Step 5.  Lift the cover off the base and set aside.

Required with optional 3M I/O Module.

Step 1.  Feed the control cable through the arm. Secure about 

6 inches (150 mm) from the end of the existing cable 

bundle using a cable tie.

Step 2.  Route control cable alongside the bundled cables and 

attach using cable ties.

Step 3.  Hang the folding wall mount base on the mounting 

screws. 

6”

(150mm)

Lanyard

cable ties

Step 1.  Lower the whiteboard stand to the lowest position 

and lock in place.

Step 2.  Adjust the two upper mounting screws so that they 

protrude approximately 3/8 in.

Step 3.  Adjust the two lower leveling screws on the 

folding arm mount base so that they protrude 

approximately 3/8 in.

Step 4.  Hang the folding wall mount base on the mounting 

screws. 

Step 5.  Install lanyard using one screw M5 x 12mm and 

one washer.