KitchenAid KVIB606DBS 使用和维护

Assemble and Install Range Hood

1. Install transition on top of hood (if removed for shipping) with 

2 - 3.5 x 9.5 mm sheet metal screws.

2. Position the 4 vertical supports (A) with notches at the bottom, 

and then attach to the range hood using 16 - 4.2 x 8 mm 
screws. 

3. Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws.

4. Attach a second set of vertical supports (A), and then set the 

vertical height (B). See “Installation Dimensions” in the 
“Location Requirements” section to help determine the 
desired dimension for vertical height (B). Secure with 
16 - 4.2 x 8 mm T20

® 

 screws.

5. Using 2 or more people, lift the range hood assembly and 

attach it by snapping the vertical supports to the spring clips 
in the upper horizontal support bracket that is mounted to the 
ceiling.

NOTE: The range hood assembly must be held in place while 
installing the screws in the next step.

6. Install 16 - 4.2 x 8 mm screws, and then tighten to secure.

1. Install vent system.

2. Push duct over the exhaust outlet. Seal all connections with 

vent clamps.

3. Use caulk to seal all openings.

1. Attach the air deflector to the upper horizontal support using 

4 mounting screws.

2. Measure the length of 6" (15.2 cm) duct needed to connect 

the transition to the deflector.

NOTE: Vent should fit up inside the deflector 1" (2.5 cm) 
minimum.

3. Install vent between the transition and the deflector.

NOTE: To make vent installation easier, temporarily remove 
the deflector from the chimney support bracket, and then 
replace after vent section is in place.

4. Seal all connections with vent clamps.

B

A

B

A

A

B

A

A

A

B

B

A