KitchenAid 24'' 6-Cycle/6-Option Panel-Ready Dishwasher 安装指导

  

   

Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so.

Install the custom hardware handle(s) on the front of the wooden 
panel inside dotted line.
IMPORTANT: If the handle is attached from the back of the 
custom panel, the screw holes should be countersunk for the 
screws heads to be flush with the panel. If the handle is attached 
to the front of the custom panel, the screw lengths cannot exceed 
the panel thickness.

Using the template provided, attach it to the backside of the 
custom panel with tape. Make sure that the center of the template 
is aligned with the center of the wooden panel and top of the 
template is aligned to the top face of the wooden panel.

NOTE: Do not drill deeper then 

⁵⁄₈" (16 mm) to keep from 

drilling through panel. Pilot hole depths given are for

 ³⁄₄" 

(19 mm) thick panel.
Mark 4 pilot holes on the wooden panel using the template 
provided. Pre-drill 4 pilot holes using a 

³⁄₃₂" drill bit. Use tape 

to mark the drill bit to gauge hole depth. Drill pilot holes 
approximately 

⁵⁄₈" (16 mm) into the custom panel.

Attach the 4 plastic studs to the wooden panel using the four 

⁵⁄₁₆" hex-head (short) screws provided.