KitchenAid 24'' 6-Cycle/6-Option Panel-Ready Dishwasher 安装指导
3
3
3
3
3
3
Check custom tape alignment with metal door slots; verify tape
is right-side up, and that the tape does not overhang the metal
door on the top, bottom or side interfaces. Remove the backing
from the custom tape by pulling straight down on the liner. Align
the custom tape to the keyhole slots on the metal door (see the
previous illustration) and apply. Repeat steps for one side and
then the other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment to the metal door needs to occur
on the first try.
is right-side up, and that the tape does not overhang the metal
door on the top, bottom or side interfaces. Remove the backing
from the custom tape by pulling straight down on the liner. Align
the custom tape to the keyhole slots on the metal door (see the
previous illustration) and apply. Repeat steps for one side and
then the other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment to the metal door needs to occur
on the first try.
Align the studs on the custom wood panel to the keyhole slots on
the door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide wood panel down until the top surface of
the wooden panel is flush with the top of the door.
the door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide wood panel down until the top surface of
the wooden panel is flush with the top of the door.
Open the door and align top edges. Use tape to mark a
³⁄₃₂" drill
bit to gauge the hole depth of approximately 1
¹⁄₂" (3.8 cm).
Drill pilot holes into the top corners of the door, using hole in
liner as a guide.
liner as a guide.
Using a Torx
®
T15
®
screwdriver, install two #8 x 1
³⁄₈" screws
in top corners to secure custom wood panel in place.
Remove the short screws (3rd from top) on either side of the
inner door panel. Use tape to mark a
inner door panel. Use tape to mark a
³⁄₃₂" drill bit to gauge the
hole depth of approximately 1
¹⁄₂" (3.8 cm). Drill 2 pilot holes using
the door liner hole as a guide into the panel. Install the 2 remaining
long screws.
long screws.