KitchenAid 30-Inch 4-Burner Dual Fuel Slide In Range, Architect® Series II 使用和维护

IMPORTANT: Your cooktop is factory-set for use with Natural 
gas. If you wish to use LP Gas, an LP Gas Conversion Kit is 
included with your new range. Models with the TripleTier

®

 Flame 

Burner will include a TripleTier

®

 Burner LP Gas Conversion Kit 

and a kit for standard ranges. See “Installation Instructions” for 
details on making this conversion.

Electric igniters automatically light the surface burners when 
control knobs are turned to LITE.

Before setting a control knob, place filled cookware on the grate. 
Do not operate a burner while using empty cookware or without 
any cookware on the grate.

NOTE: Visually check that the burner has lit. If the burner does 
not ignite, listen for the clicking sound. If you do not hear the 
igniter click, turn the burner off. Check for a tripped circuit 
breaker or blown fuse.

Check that the control knob is pressed completely down on the 
valve shaft. If the spark igniter still does not operate, call a trained 
repair specialist.

Proper grounding and polarity are necessary for correct operation 
of the electric ignition system. If the wall receptacle does not 
provide correct polarity, the igniters will become grounded and 
occasionally click, even after the burner has ignited. Contact a 
trained repair specialist to check the wall receptacle to see 
whether it is wired with the correct polarity.  

In case of prolonged power failure, the surface burners can be lit 
manually. Hold a lit match near a burner and turn knob 
counterclockwise to LITE. After burner lights, turn knob to 
setting.

NOTE: Settings are marked on the control knob.

The TripleTier

®

 Flame Burner (15,000 Btu/h [British Thermal 

Units]) can provide the highest heat setting and 3 levels of 
simmer control. It is ideal for cooking large quantities of food or 
liquid and using large pots and pans.

1. Push in and turn knob counterclockwise to LITE.

All surface burners will click. Only the simmer burner with the 
control knob turned to Lite will produce a flame.

2. Push in and turn knob counterclockwise to POWER BURNER 

HI. All 3 burner rings will produce a flame. 

3. Turn knob to anywhere between POWER BURNER HI and 

POWER BURNER LO.

Use the following chart as a guide when setting Power Burner 
heat levels.

1. Push in and turn knob counterclockwise to LITE.

All surface burners will click. Only the simmer burner with the 
control knob turned to Lite will produce a flame.

2. Push in and turn knob counterclockwise to anywhere 

between SIMMER BURNER HI and SIMMER BURNER LO.

REMEMBER: When range is in use or (on some models) 
during the Self-Cleaning cycle, the entire cooktop area may 
become hot.

■

Start food cooking.

■

Bring liquid to a boil.

■

Wok cooking.

■

Maintain a slow boil.

■

Fry poultry or meat.

■

Cook pudding, sauce, icing or 
gravy.

■

Fry or sauté foods.

■

Hold a slow boil.