avolites pearl expert titan 用户手册

3. Controlling dimmers and fixtures  - Page 41

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

toggle the option to [Remember Mask] which will keep the 

mask setting you used last time. 

• 

[Clear/Don’t Clear Located Attributes] sets whether the 

attributes changed by the Locate function will be saved into any 

cues you store. If the option is set to “Clear” then the Located 

attributes will not be stored in the Programmer unless you 

modify them using the wheels. This is useful if for example you 

want to program a cue which sets the position of fixtures, but 

does not turn them on. The Locate button will light up the 

fixtures for programming, but the lit state will not be stored in 

any cues you save. 

The Clear button (on the right of the numeric keypad) is used to 

remove all changes from the Programmer and deselect all fixtures.  A 

quick press of the Clear button just clears everything, however if you 

hold down the Clear button, then more options are available. 

• 

You can mask which attributes are to be cleared (for example, 

leaving the pan/tilt in the programmer but clearing everything 

else) by holding down Clear and pressing B [Set Mask to Clear 

Nothing]. Then (still holding Clear) turn on the Attributes you 

want to change using the Attribute Bank buttons down the right 

hand side, or press A [Set Mask] and use the softkeys. Only the 

lit attributes will be cleared. Pressing the Attribute Options 

(Bank Select) button will clear the mask.   

• 

[Clear Options] opens a submenu showing some further options 

(described below). 

• 

[Clear All Fixtures/Selected Fixtures] sets whether all fixtures 

will be cleared from the programmer, or if only currently 

selected fixtures will be cleared. This is useful if you want to 

clear specific fixtures. 

• 

[Individual Attributes] allows you to clear individual attributes 

from the Programmer. When you press the option, you are 

given a list of attributes in the Programmer – press the 

appropriate softkey to clear that attribute. 

The options in the “Clear Options” submenu allow you to: 

• 

[Auto Reset Mask] sets the mask to be automatically reset to 

clear everything each time Clear is pressed, or you can toggle 

the option to [Remember Mask] which will keep the mask 

setting you used last time. 

• 

[Leave/Zero Preset Fader Levels] sets how the console deals 

with intensity levels which are set on the preset faders. 

Normally pressing Clear will remove levels from the 

Programmer, but the intensity will remain set on the output. If 

this option is set to [Zero Preset Fader Levels] then the 

intensity will also be set to zero on the output. This is useful to 

kill fixtures which have been left on from a different fixture 

page. 

• 

[Freeze current values] sets what happens to LTP (non-

intensity) channels you have modified. If set to [Freeze Current 

Values] the channels remain as you set them. If set to [Release 

To Playback Values] the channels will go back to how they are 

set in the current playback. For example: you have an active