avolites pearl expert titan 用户手册

Page 62 – 5. Shapes

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

Workspace Window] then [Channel Grid] or press the dedicated 

Channel Grid button.  

Shapes get more interesting (and look more impressive) when you 

apply them to multiple fixtures. The Pearl lets you control how a 

shape is phased across several fixtures. You can also control Spread, 

which is a different way of selecting the same thing. 
The sequence of the shape across the fixtures is controlled by the 

order in which you selected the fixtures when you created the shape.. 

 

 
The display above the left hand wheel shows the phase in degrees. 

For example, 180 degrees repeats every 2 fixtures, 90 degrees 

repeats every 4 fixtures, 60 degrees repeats every 6 fixtures, and so 

on.  
The Phase Offset function allows you to set the starting phase of the 

shape, when more than one shape is running. Press Softkey E again 

to select [Adjust Phase Offset]. For example, if you were running a 

Cyan shape and a Magenta shape to create a mix of colours, you 

would probably want to start them with Cyan at full and Magenta at 

zero to give the full range of colours. In this case you would set one 

of the shapes to have a Phase Offset of 180 degrees. Without the 

phase offset, both shapes would reach full at the same time. 

Phase=180 deg (Spread=2 fixture) 

Phase=60 deg (Spread=6 fixture) 

Phase=22.5 deg (Spread=16 fixture) 

Phase=0 deg