avolites pearl expert titan 用户手册

Page 74 – 6. Cues

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

groups, and for each individual attribute, see next section for 

details of this. 

 
The times you enter are affected by the cue mode which is set using 

E [Fade Mode]: 

• 

Mode 0 – Channels will fade in as set by the fade time. The 

Fade Out time is ignored. If times are set to zero, the HTP 

channels fade in with the 0-100% position of the playback fader 

and the LTP channels will snap. 

• 

Mode 1 - Channels fade in as set by the fade time. HTP 

channels fade out as set by the fade out times (LTP channels 

remain as set in the cue). If times are set to zero, the HTP 

levels will fade in and out with the fader and the LTP channels 

will snap when the cue is fired. 

• 

Mode 2 – Channels will fade in as set by the fade time. The 

Fade Out time is ignored. However, the fade will stop when the 

fader position is reached, so if the fader is set to 50%, the 

attributes will stop half way to their programmed position. You 

can reverse the fade back to the original position by moving the 

fader back. If times are set to zero, both HTP and LTP channels 

are controlled by the fader position. 

In this mode LTP channels revert to their previous settings 

when the cue is deactivated. 

• 

Mode 3 - Crossfade cue. All channels, including intensity 

channels, will fade to the settings in the new cue. All other cues 

fade out and all other active playbacks become inactive; if you 

need to re-fire a playback, take the fader to zero and put it up 

again. 

• 

If the cue includes shapes, then the shape will change with fade 

times. The changes will be timed for a Mode 1 cue and 

controlled by the fader position for a Mode 2 cue. This allows 

you to create a shape which gets bigger or faster as you push 

up the fader. 

You can change the order of the fixtures stored in a cue. Normally 

this is set to the order in which you selected the fixtures when the 

cue was created, but you might want to change this (for example to 

pair up fixtures so they move together).