Runco cx-52hd 用户手册
Runco CX-52HD/CX-57HD Owner’s Operating Manual
23
PRE
L
IMINAR
Y
4.1
Turning on the Power
Turning on the Power
1.
Turn on your source components.
2.
Plug the female end of the supplied power cord into the AC receptacle on the rear of
the Crystal Series LCD (AC 100V ~ 240V). See Figure 2-2.
the Crystal Series LCD (AC 100V ~ 240V). See Figure 2-2.
3.
Connect the other end to your AC power source.
4.
Turn on the main power switch at the rear of the display. The power indicator lights
red to indicate that the Crystal Series LCD is in “standby” mode.
red to indicate that the Crystal Series LCD is in “standby” mode.
5.
Press the ON button on the remote control to
turn on the display (or press the power button
on the side of the display). The power indicator
lights solid green.
turn on the display (or press the power button
on the side of the display). The power indicator
lights solid green.
6.
After a brief warm-up period (approximately 10
seconds), the Crystal Series LCD will display
an image.
seconds), the Crystal Series LCD will display
an image.
4.2
Changing the OSD
Language
Changing the OSD
Language
The Crystal Series LCD OSD language is initially set to English, but can also display the
menus in French, Spanish, Portuguese or German. To change the OSD language:
menus in French, Spanish, Portuguese or German. To change the OSD language:
1.
Press MENU.
2.
Select Setup from the Main Menu.
3.
Select OSD Language from the Setup Menu.
4.
Press
or
to highlight the desired language and press ENTER. The change takes
effect immediately.
4. Operation
4
5
1
2
3
6
7
8
9
OFF
ON