Honeywell T7350 用户手册

63-2605—5

30

See Table 20 for the advanced setup options available 

through a PDA.

NOTE: Upon initial thermostat power-up, wait at least 30 

seconds before connecting the TIM.

The Thermostat Configuration Tool has the following 

configuration:

• PDA hardware platform supporting application software.

• Serial Connection Cable with TIM. The interface plug 

connects to the thermostat socket.

Disconnect the TIM cable prior to opening or closing 

the thermostat cover.

It is best to set the clock before downloading anything else to 

the thermostat. Connect to the thermostat and set the clock. 

NOTES:

—

When setting the clock the first time, the PDA 

displays an incorrect T7350 Clock time, day, and 

date.

—

Day-of-Week mode forces the T7350 to ignore 

holidays.

The PDA Configuration Tool can perform a variety of tasks:

• Configure the thermostat.

• Calibrate the thermostat.

• Perform diagnostics.

NOTE: To install the configuration tool on a second PDA:

1.

Power up both PDAs.

2.

Execute the following command sequence from 

the source PDA: Menu, Beam, T7350, Beam.

Whether the configuration is performed offline or while 

connected, the procedure is the same.

OFFLINE CONFIGURATION
While disconnected from the thermostat, you can arrange and 

save named configurations.

NOTE: The user can note the Configuration ID and manually 

set the code using the T7350 user interface.

CONNECT AND CONFIGURE
Connect to a thermostat and:

— configure device with existing named parameter 

arrangement,

— configure device by changing all parameters

— read the existing configuration parameter values and

— change one or more configuration parameters

— save new configuration file.

NOTE: The configuration tool verifies that the subbase 

supports the existing arrangement.

1. Enter the T7350 PDA application. (See Fig. 27.)

2. If disconnected, the only usable functions are:

a. New Config:

(1) Enter a name for the configuration.

(2) Tap New Config.

(3) Proceed to Select Existing Config(uration) 

section.

b. Select Existing Config: See below.

Select Existing Config(uration)
This function is used to select a programmed configuration 

when setting up/programming a T7350. This can be useful 

when you use any given configuration more than once.

NOTES:

—

You can modify details of a given configuration 

prior to downloading it into any particular T7350.

—

The PDA tool will notify you when a selected 

configuration requires more stages/features than 

the T7350 into which you are downloading it.

—

Configuration screens will vary depending on the 

T7350 model selected.