lift-master 500lm 用户手册
THE TRANSMITTER
The portable transmitter may be secured to a car sun visor with
the clip provided. Additional transmitters can be purchased at
any time for use in all vehicles using the garage. New
transmitters must be set to the same code as original transmitter.
Follow code setting procedures below.
The portable transmitter may be secured to a car sun visor with
the clip provided. Additional transmitters can be purchased at
any time for use in all vehicles using the garage. New
transmitters must be set to the same code as original transmitter.
Follow code setting procedures below.
The transmitter is equipped with a battery check light. When the
push button is pressed, the light will glow if the battery has power
(and the opener will operate).
push button is pressed, the light will glow if the battery has power
(and the opener will operate).
The 12 Volt battery should produce power for at least a year.
When the light is dim or doesn’t come on, replace the battery. If
the transmission range lessens, check the battery light.
TO CHANGE THE BATTERY: Slide the battery compartment
cover down. Remove original battery and position new battery
as directed.
When the light is dim or doesn’t come on, replace the battery. If
the transmission range lessens, check the battery light.
TO CHANGE THE BATTERY: Slide the battery compartment
cover down. Remove original battery and position new battery
as directed.
KEY
NO.
NO.
PART
NO.
NO.
DESCRIPTION
KEY
NO.
NO.
PART
NO.
NO.
DESCRIPTION
1
41A3593
Transmitter case (housing only)
(Circuit board NOT INCLUDED)
(Circuit board NOT INCLUDED)
4
500LM
Universal Receiver
2
10A14
12V Battery
5
85
Transformer Accesory
3
329C128
Visor Clip
NOT
SHOWN
Model
61LM
61LM
Extra Transmitter (Complete)
MATCHING/CHANGING THE CODE
SET CODE SWITCHES IN ALL TRANSMITTERS TO MATCHING POSITIONS
1. Of the back of the transmitter(s) slide the battery compartment cover down to access the code switches.
2. With a pen or screwdriver, change the setting of one or more switch to a (+), (-) or (0) position.
3. NOTE: Code switches 2 through 9 in ALL transmitters used to operate a receiver must be set to
2. With a pen or screwdriver, change the setting of one or more switch to a (+), (-) or (0) position.
3. NOTE: Code switches 2 through 9 in ALL transmitters used to operate a receiver must be set to
match. (Code switch 1 is neutral. Set it to ANY position. It will not affect the code selected).
SET RECEIVER TO MATCH TRANSMITTER CODE
1. Pry open the front panel of receiver case with a coin
screwdriver.
2. Press the “Smart” actuator on the receiver as shown. The
indicator light alongside will turn ON.
CAUTION: The door will move immediately if a neighbor or
family member is operating a remote control transmitter.
family member is operating a remote control transmitter.
3.
STAND AWAY FROM DOOR and press the transmitter
push button. The actuator indicator light will turn OFF
and the door will move. Code setting is now complete and
push button. The actuator indicator light will turn OFF
and the door will move. Code setting is now complete and
the opener will operate when either the wall push button or
the transmitter push is pressed. Return cover to receiver.
the transmitter push is pressed. Return cover to receiver.
NOTE: If the transmitter push button is not pressed within 30
seconds, the receiver indicator light will turn OFF. Repeat
steps 1 and 2.
seconds, the receiver indicator light will turn OFF. Repeat
steps 1 and 2.
114A1209B
Printed in Mexico