Redline Communications Inc. AN100UA 用户手册
Red
MAX
™
Base Station
User Manual
Doc. #70-00058-01-01
Proprietary Redline Communications © 2007
July 13, 2007
Page 79 of 119
5.2.3 interfaces
The interfaces command is used to view and configure the front panel Data and
Management (Mgmt) Ethernet ports.
Management (Mgmt) Ethernet ports.
Table 24: CLI - Interfaces Command
Interface
Command
Parameter/Description
ethernet
Ethernet port settings.
IntSep
Select integrated or separated management mode.
0:
0:
The Data Ethernet port is used for data and local
management traffic. The Mgt Ethernet port is
disabled.
management traffic. The Mgt Ethernet port is
disabled.
1:
Only the Mgt Ethernet port is monitored for local
management traffic. Select this mode only when data
and management networks are physically isolated.
management traffic. Select this mode only when data
and management networks are physically isolated.
DataDuplex
Data Ethernet port settings.
0:
0:
Auto-detect speed and duplex.
1:
Operate at 10Base-T half duplex mode only.
2:
Operate at 10Base-T full duplex mode only.
3:
Operate at 100Base-T half duplex mode only.
4:
Operate at 100Base-T full duplex mode only.
MgmDuplex
Management Ethernet port settings.
0:
0:
Auto-detect speed and duplex.
1:
Operate at 10Base-T half duplex mode only.
2:
Operate at 10Base-T full duplex mode only.
3:
Operate at 100Base-T half duplex mode only.
4:
Operate at 100Base-T full duplex mode only.
Intra-
SectorL2Forwar
Establish a virtual private network at layer 2 between any
number of subscriber CPEs in single sector.
0:
number of subscriber CPEs in single sector.
0:
Disabled - base station will not accept traffic
resubmitted to the Ethernet port
resubmitted to the Ethernet port
1:
Internal - base station creates a service flow to
provide transparent tunneling for higher-layer
protocols
provide transparent tunneling for higher-layer
protocols
2:
External - base station allows an external switch to
forward VLAN traffic back through the (originating)
base station Ethernet port and over the wireless.
forward VLAN traffic back through the (originating)
base station Ethernet port and over the wireless.
default
Restore all settings to factory default values.
management
Management configuration settings.
LocalIp
Enter the static base station network IP address.
LocalMask
Enter the base station subnet address mask.
DefGateway
Enter the IP address of the default gateway on the local
Ethernet segment.
Ethernet segment.
DhcpEnable
:
0:
0:
Manually enter the following IP parameters
1:
Have the base station obtain its IP address from a
DHCP server.
ToDIP
Enter the IP address of an the SNTP server.