Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 29 of 136
April 19, 2010
Wireless LEDs
Link LED
The wireless Link LED flashes once every 8 frames to provide a 'heartbeat' indicator.
This indicates proper communication with the outdoor unit (ODU), and that the framer is
operating correctly. If this LED is not flashing, there is no possibility of establishing a
wireless link.
This indicates proper communication with the outdoor unit (ODU), and that the framer is
operating correctly. If this LED is not flashing, there is no possibility of establishing a
wireless link.
Table 10: System - Wireless Link LED Indications
LED State
Description
OFF
Wireless interface unavailable.
FLASH
Wireless interface enabled and functioning correctly.
Signal LED
The Signal LED flashes each time a message is received from any subscriber. Message
types include: periodic ranging messages, bandwidth requests, and user data traffic.
types include: periodic ranging messages, bandwidth requests, and user data traffic.
Table 11: System - Wireless Signal LED Indications
LED State
Description
OFF
No wireless link activity.
ON
Messages being received from subscribers.
3.1.4 Ethernet Section
This section describes the Ethernet LEDs and port connections.
Figure 10: System - AN-100U/UX Front Panel Ethernet LEDs and Ports
Data Port
The Data port is always enabled. The port can be programmed to operate in full duplex
or half duplex mode and at 10 Mbps or 100 Mbps.
or half duplex mode and at 10 Mbps or 100 Mbps.
Data Port LEDs
Data Port Link/Act LED
The Link/Act LED lights green when the LAN is functioning properly.
Table 12: System - Ethernet Data Port Link/Act LEDs
LED
Description
ON
Link is present.
FLASH
Link is present and there is data activity.
OFF
Link is not active.
Data Port 100 LED
The 100 LED lights solid green when the terminal is operating at 100 Mbps. The LED is
off when operating at 10 Mbps.
off when operating at 10 Mbps.