Redline Communications Inc. AN30 用户手册

 

 

AN-30 System User Manual 

 

 
This section of the manual presents a basic overview of the steps required to install the 
AN-30 terminal, outdoor transceiver, antenna and associated equipment.    
 
Figure 7 below illustrates the primary system components and cables. The power cord 
connects to a 110/220/240 VAC standard power outlet or to a 48 VDC, while the CAT 
5/UTP cable (not included) connects the terminal to the data network via a standard 
10/100BaseT Ethernet connection. The provided IF cable connects the terminal (located 
indoors) to the T-58 Transceiver (located outdoors), and carries the transmitted and 
received signal, DC power for the AN-30 radio, as well as control and reference signals. 
Note that the provided IF cable is meant for exterior use, and should be used for only 
minimal interior runs to connect to the terminal.  Also note that the BNC connectors are 
for future use.  

 

 

(AC shown)

The terminal is for indoor installation only, while the transceiver and antenna (together 
known as the AN-30 Radio) are mounted externally. The principal steps in installation are: 

1.  Conduct a general site survey 
2. Install the antenna 
3.  Install the IF cable 
4.  Install the AN-30 terminal 
5.  Align the antenna 

 
Each step is addressed in more detail below. 

Page 19 of 80 

Redline Communications