Redline Communications Inc. AN30 用户手册
AN-30 System User Manual
Basic Ethernet access is provided solely for the purpose of managing the AN-30
system. Using this port for user data traffic requires installation of the high speed data
option in order to avoid impacting TDM performance.
The key is personalized to each unit’s MAC address. Please ensure that the correct MAC
address is provided when requesting a key from your local Redline representative, or
register directly at
system. Using this port for user data traffic requires installation of the high speed data
option in order to avoid impacting TDM performance.
The key is personalized to each unit’s MAC address. Please ensure that the correct MAC
address is provided when requesting a key from your local Redline representative, or
register directly at
Use the following CLI command to enter the “Option Key”:
set optionskey <key_value>
Note, if the key_value is not correctly entered, it will not be saved and the options will
not be selected. Please note that the option key is case sensitive.
8.7. System
Logs
The System Logs page, shown in Figure 14, provides a list of the last forty messages
recorded by the AN-30 terminal, describing either system activity or errors that have
occurred.
108-Version control loaded successfully!
103-Parameters saved successfully!
100-Parameters loaded successfully!
101-Firmware configuration OK!
106-Firmware programmed OK!
111-SNMP configuration loaded successfully!
103-Parameters saved successfully!
105-Password changed successfully!
Figure 14: System Logs Screen
The show log CLI command can be use in order to display the log file.
The logs will also indicate if the following transactions were successfully completed:
• Save Configuration – Under the Configuration screen.
• Upload – Under the Upload Software screen.
• Upload – Under the Upload Software screen.
• Change Password – Under the System Password screen.
• Send Options Key
• Send Options Key
The following table provides a brief description of the key messages recorded in the logs
by the system:
Log Message
Description
100-Parameters loaded successfully!
All system parameters have been successfully downloaded.
101-Firmware configuration OK!
The onboard firmware configuration has been properly set up.
102-Ethernet port configured!
The Ethernet port has been properly configured and is
operational.
operational.
Page 40 of 80
Redline Communications
…..solving the first mile challenge