Raytheon Anschuetz GmbH High Seas Products MTX5 用户手册
18
Pathfinder Radar Scanners
Connecting the radome scanner inter-unit cable
CAUTION:
Before wiring the scanner unit, make sure that the inter-unit cable is not
connected and power is not applied to the display unit.
Before wiring the scanner unit, make sure that the inter-unit cable is not
connected and power is not applied to the display unit.
When you have run the inter-unit cable to the scanner location, connect the
cable as follows:
cable as follows:
1. Loosen the 4 (18") or 7 (24") screws securing the scanner cover. These
screws are captive and should remain assembled to the lower flange
assembly. Press the radome inwards to release the top. This breaks the seal
and makes removal easier.
assembly. Press the radome inwards to release the top. This breaks the seal
and makes removal easier.
2. To avoid losing the scanner cover, tie the cord, attached to the inside of the
base of the scanner, to the eye provided in the cover.
3. If you have a 24" scanner, unscrew and remove the inner cover:
D4006-1
Inner cover
4. Remove the drain tube from inside the base of the scanner, and insert it into
the drain hole as shown in the following diagram. Pull the tube gently from
outside the scanner so that it clips into place.
outside the scanner so that it clips into place.
154_2c2.p65
13/05/99, 13:18
18