Raytheon Anschuetz GmbH High Seas Products MTX5 用户手册
20
Pathfinder Radar Scanners
cable tie closest to the 8-way plug – this will not affect the ferrite
clamp’s function).
clamp’s function).
Note: on the 24" scanner, the clamp must be contained inside the inner
cover.
cover.
- With the clamp positioned correctly, close the clamp ensuring none of
the cores are trapped by the hinge, latch or the ferrite itself.
9. Connect the 8-way plug (4) to the connector (5). The correct fitting is with
the small arrow marked on the body of the plug facing upwards and to the
left hand side. The grey wire will then be at the left hand side and the white
wire will be at the right hand side.
left hand side. The grey wire will then be at the left hand side and the white
wire will be at the right hand side.
10. Connect the red and black power cores (6).
If you have a 10 m or light 15 m inter-unit cable, there is one pair of cores.
Connect the red cable lead to one of the terminal sockets marked “+”, and
the black cable lead to one of the sockets marked “-”.
Connect the red cable lead to one of the terminal sockets marked “+”, and
the black cable lead to one of the sockets marked “-”.
If you have a heavy 15 m inter-unit cable, there are two pairs of cores.
Connect the red cable leads to the terminal sockets marked “+”, and the
black cable leads to the terminal sockets marked “-”, with one lead in each
socket.
Connect the red cable leads to the terminal sockets marked “+”, and the
black cable leads to the terminal sockets marked “-”, with one lead in each
socket.
The terminal clamps (7) are operated using a screwdriver (8), as shown in
the inset diagram on the previous page.
the inset diagram on the previous page.
CAUTION:
Do not earth the cable screen to the scanner. The radar system is earthed
via the display unit.
Do not earth the cable screen to the scanner. The radar system is earthed
via the display unit.
11. Secure the nut (1) on the watertight gland, making sure that it grips the
cable’s outer sheath.
12. Secure the cable with the cable clamp (9), using the two screws (10)
provided. The clamp can be installed either way up, depending on the
thickness of the cable: use the position that matches the profile of the cable.
thickness of the cable: use the position that matches the profile of the cable.
CAUTION
It is essential that the drain tube is fitted and that the nut on the watertight
gland is adequately tightened. If this is not done, water could become
trapped in the scanner and cause irrepairable damage.
It is essential that the drain tube is fitted and that the nut on the watertight
gland is adequately tightened. If this is not done, water could become
trapped in the scanner and cause irrepairable damage.
13. Tighten the securing nut (1) again to ensure a waterproof seal.
14. If you have a 4D scanner, replace the inner cover over the connectors.
15. Untie the cord from the scanner cover, and coil it up in the base of the
scanner unit so that it cannot foul the rotating antenna.
16. Replace the scanner cover, aligning the mark on the cover with the mark on
the scanner base above the cable gland, and tighten the 4 or 7 captive
screws. Do not over-tighten these screws.
screws. Do not over-tighten these screws.
154_2c2.p65
13/05/99, 13:18
20