Elica ELN136SS 安装指导

 

•  From the horizontal line traced in the previous section, trace a  

 

horizontal parallel line as shown below.

•  Center the bracket in the top horizontal line and align it with the 

 

centerline, as described in the following drawing. 

Centerline

Bracket line

Horizontal straight pencil marked line
Desired installation height

 

Mark screw holes locations in the wall. 

IMPORTANT. Check to be sure that holes locations are  

leveled, and correctly centered by the vertical centerline.

Drill 

5

⁄

16

” pilot holes in the marked locations.

Install wall fastener anchors.

Drive wood 2 - 5 x 45 mm screws, by hand, into the fasteners to allow 

anchors to expand. Remove screws. 

 

Secure the bracket to the wall with wood screws and/or fasteners. 

•  If drywall is present, mark the screw hole locations. 

•  Cut away enough drywall to expose 2 vertical studs at the holes 

 

location indicated by the template. 

 

Install two horizontal supports at least 4 x 2” between two wall 

 

studs at the bottom and upper mounting holes installation location.

•  The horizontal support must be flush with the room side of the 

 studs.

•  Use cleats behind both sides of the support to secure to wall studs.

•  Reinstalll drywall and refinish 

IMPORTANT- Framing must be capable of supporting 100 lbs. 

 

8½” min. opening for ductwork

View from rear 

cleats

1” x 6” min 

Mounting Support

Centerline of 

installation 

space

Mounting the hood 

WARNING: 2 people are required to lift and position the hood onto the 

mounting screws.

•  Place the template on the wall along the horizontal line, make sure 

 

the template is leveled and centered with the centerline.

•  Mark upper screw holes locations in the wall.

•  IMPORTANT. Check to be sure that hole locations are leveled and 

 

correctly centered by the vertical centerline.

•  Drive 2 - 5 x 45 mm upper wood screws by hand. Leave ¼ “ of 

 

distance between the screw head and the wall. 

¼” 

(6.4mm)

•  Remove the grease filter and mount the hood onto the upper 

 screws. 

NOTE: The screws provided for mounting this hood must be fastened 

into solid wood, do not fasten into sheet rock only. 

 

 

1.  Determine and make all necessary cuts in the wall for the vent 

 

system. Install the vent system before installing the range hood. 

 

See the “Venting Requirements” section.

2.  Determine the location where the power supply cable will be run 

 

through the wall.

3.  Drill a 1¼” (3.2 cm) hole at this location.

4.  Pull enough power supply cable through the wall to allow for easy 

 

connection to the terminal box.

5.  Install the 8” (20.3 cm) round vent transition with damper to top 

 

of the range hood using 4 - 3.5 x 9.5 mm screws.