KitchenAid KOWT107ESS 安装指导

IMPORTANT: The warming drawer must be electrically grounded 
in accordance with local codes and ordinances, or in the absence 
of local codes, with the National Electrical Code, ANSI/NFPA 70 or 
Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that 
the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575

■

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is 
required. A time-delay fuse or circuit breaker is also 
recommended. It is recommended that a separate circuit 
serving only this warming drawer be provided.

■

The model/serial/rating plate is located above the left-hand 
side receiving slide. The warming drawer must be removed to 
view the model/serial/rating plate. See the illustration below.

1. Turn off power supply. Using 2 or more people, move 

warming drawer close to its final location. Remove and 
discard shipping materials, tape, and film from the warming 
drawer. Remove and set aside racks and other parts from 
inside warming drawer. 

2. Check that the warming drawer Temperature control knob is 

set to the OFF position.

3. Support the warming drawer on a sturdy surface level with 

the cutout opening.

4. Plug the power supply cord into the grounded 3 prong outlet.
5. Slide the warming drawer over halfway into the cutout 

opening.

6. Open warming drawer and slowly push against the front 

panel to slide the drawer completely into the cabinet until the 
flanges on the front panel meet the cabinet face.

A