KitchenAid KOWT107ESS 安装指导

下载
页码 16
7
7. Use the two #8-18 x 
¹⁄₂" screws provided to secure the 
warming drawer frame to the cabinet.
Complete Installation
1. Check that all parts are now installed. If there is an extra part, 
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For warming drawer use and cleaning, read the Use and Care 
Guide.
5. Push in and turn the control knob to HI, and the light should 
illuminate.
If warming drawer(s) does not operate, check the 
following:
Household fuse is intact and tight; or circuit breaker has not 
tripped.
Warming drawer is plugged in, and electrical supply is 
connected.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use 
and Care Guide or contact the dealer from whom you purchased 
your warming drawer.
CUSTOM DRAWER FRONT INSTALLATION INSTRUCTIONS
FOR WARMING DRAWERS
Tools and Parts
Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.
Tools Needed
Phillips screwdriver
Drill and appropriate bits
Parts Supplied
6 - #8-18 x 
¹⁄₂" screws
Indicator light lens
Parts Needed
Custom drawer front
Custom handle (optional)
Adhesive recommended for plastic to wood
Install Custom Drawer Front Panel
The warming drawer has an interface that will allow a modest 
range of panel sizes. The actual panel size should be selected by 
the customer and the contractor to suit the desired effect. It is 
recommended that a qualified carpenter make and install the 
custom drawer front and handle(s) to match surrounding 
cabinetry.
1. Install warming drawer unit as instructed by the installation 
instructions provided with the warming drawer.
2. Create the custom drawer front. Below are the minimum and 
maximum dimensions for the custom drawer front. The size 
of the custom drawer front for the warming drawer will vary 
according to the specific installation. The depth of the panel 
will vary in order to have the custom warming drawer flush 
with the surrounding cabinets.
A. Two #8–18 x 
¹⁄₂
" screws
A
Model
A - MAX
B - MAX
A - MIN
B - MIN
24" (61 cm) 
Warming Drawer
23
³⁄₄" 
(60.3 cm)
10
⁵⁄₁₆" 
(26.2 cm)
23"
(58.4 cm)
9
¹⁄₁₆" 
(23.0 cm)
27" (68.6 cm) 
Warming Drawer
26
³⁄₄" 
(67.9 cm)
10
⁵⁄₁₆" 
(26.2 cm)
26"
(66.1 cm)
9
¹⁄₁₆" 
(23.0 cm)
30" (76.2 cm) 
Warming Drawer
29
³⁄₄" 
(75.6 cm)
10
⁵⁄₁₆" 
(26.2 cm)
29"
(73.7 cm)
9
¹⁄₁₆" 
(23.0 cm)
A
B
⁵⁄₁₆
" (7.9 mm) dia. hole for 
indicator light lens (provided 
in this kit). Locate lens directly
in front of indicator light.