GE 82-POE 用户手册

 

Chapter 2: Installation 

GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual 

17 

Connection to the Managed Switch requires UTP Category 5 network cabling 

with RJ-45 tips.  Refer to the Cabling Specification in Appendix A for further 
information. 

Step 4: Connect the Managed Switch to network devices. 

A. Connect one end of a standard network cable to the 10/100/1000 RJ-45 ports 
on the front of the Managed Switch. 
B. Connect the other end of the cable to the network devices (printer servers, 
workstations, routers etc). 

Step 5: 

Supply power to the Managed Switch

. 

A. Connect socket end of the power cable to the socket on the Managed Switch 
rear panel. 
B. Connect the power cable plug to a standard wall outlet. 
C. Switch the power switch on the rear panel to ON. When the Managed Switch 
receives power, the Power LED should light and remain solid Green. 

Use the following instructions to install the Managed Switch in a 19-inch standard 
rack. 
Step 1: Place the Managed Switch on a hard flat surface, with the front panel 
positioned towards the front. 

Use only the screws supplied with the mounting brackets. Damage caused 

by using incorrect screws will invalidate the warranty. 

Step 2: Attach the rack-mount bracket to each side of the Managed Switch.  Use the 
supplied screws attached to the package. Figure 6 shows how to attach brackets to 
one side of the Managed Switch. 

 

Step 3: Secure the brackets tightly, but do not over tighten screws.