Toshiba D-R17DTKB 用户手册

24

EN

Programme the tuner to scan only the channels you 
can receive in your area.

U / D], 

General Setting Menu will appear.

U / D], then 

U / D], then press 

U / D], 

The unit will start storing channels available in 
your area.

Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel 

901-999 after it is scanned by this unit.

You can select only the channels memorised in 
this unit by using [PROG.  

/ ].

To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.

• The selection will be affected by how you receive TV 

channels in your local area.

• If the auto tuning is cancelled during scanning, 

some channels not yet tuned may not be received.

• You cannot change the channel when DVD is in any 

recording mode (normal recording, One-touch Timer 
Recording or timer recording).

You can preset an analogue channel manually and 
individually.

U / D], 

U / D], then 

U / D], then press 

U / D], then press [ENTER/OK].

U / D], then 

P].

U / D], then press [L].

• You can select position number 901-999.
• With [the Number buttons], you only need to 

enter the last 2 digit numbers. 

U / D], then 

P].

U / D] to start scanning.

• The tuner will begin to search up or down 

automatically. When a channel is found, the unit 
will stop searching and the picture will appear 
on the TV screen.

• You can select a desired channel number using 

[the Number buttons]. Refer to the following 
Channel Plan table and press the three digits to 
select the channel number.
(To select channel 4, press [0] first and then 
press [0] and [4]. Or press [4] and then “– – 4” 
appears and wait for 2 seconds.)

• If this is the channel you want, press [

L].

01 – 10

IRA-IRJ, GAP

21 – 69

E21 – E69

74 – 78

X, Y, Z, Z+1, Z+2

80 – 99, 100

S1 – S20, GAP

121 – 141

S21 – S41

E7J70BD_EN.book  Page 24  Monday, May 7, 2007  3:31 PM